HPlogo   HP-PB 100Base-T Network Adapter Installation and Service:
HP 3000 MPE/iX Computer Systems
> Chapter 1 Installation Procedure

Chapter 1 Installation Procedure

MPE documents

Complete PDF

 

Table of Contents

Glossary

Index

 

⇓ Page Bottom

⇑ Page Top

 

In This Book

1. Prepare to Install the Adapter

Table of Contents

1. Prepare to Install the Adapter
Observe Antistatic Precautions
Verify Product Contents
Record Adapter Information
Gather Tools and Accessories
2. Shut Down the Operating System and Switch Off the Computer
3. Install the Adapter
a. Access the adapter slot(s)
b. Select an available slot
c. Insert the adapter into the slot
d. Switch on the power to the computer.
4. Attach the Adapter to the Network
5. Configure the Adapter into the System
6. Verify Operation
This section contains installation instructions for the HP-PB 100Base-T Network Adapter. The instructions are organized into six primary steps listed below. Each step is described in detail in this section. If the adapter has already been installed at the factory, you may proceed directly to step 4.
  1. Prepare to install the adapter.
  2. Shut down the operating system and switch off the computer.
  3. Install the adapter.
  4. Attach the adapter to the network.
  5. Configure the adapter into the system.
  6. Verify operation.



In This Book

1. Prepare to Install the Adapter