HPlogo   HP-PB 100Base-T Network Adapter Installation and Service:
HP 3000 MPE/iX Computer Systems
> Chapter 1 Installation Procedure

2. Shut Down the Operating System and Switch Off the Computer

MPE documents

Complete PDF

 

Table of Contents

Glossary

Index

 

⇓ Page Bottom

⇑ Page Top

 

1. Prepare to Install the Adapter

3. Install the Adapter

  1. Before installing the HP-PB 100Base-T Network Adapter, ensure that the operating system is shut down. Refer to your computer system manuals for proper shutdown procedures to avoid corruption or loss of data.
  2. Ensure that power to the host computer is switched off and disconnected from the source power supply.
Note
WARNING! Unless otherwise noted in your computer system manuals, failure to properly shut down the system and remove power may create a personnel hazard, or may result in hardware damage or data corruption.



1. Prepare to Install the Adapter

3. Install the Adapter