HPlogo   Configuring and Managing Host-Based X.25 Links:
HP 3000 MPE/iX Computer Systems
> Chapter 6 Configuring X.25 Links Step-by-Step

Chapter 6 Configuring X.25 Links Step-by-Step

MPE documents

Complete PDF

 

Table of Contents

Glossary

Index

 

⇓ Page Bottom

⇑ Page Top

 

Identify Neighbor Gateways

Modify the Network Management Configuration File

Table of Contents

Modify the Network Management Configuration File
Step 1: Begin the Configuration Process
Step 2: Open the Configuration File
Step 3: Select NS Configuration
Step 4: Select Guided Configuration
Step 5: Perform Guided Network Transport Configuration
Step 6: Configure X.25 Network
Step 7: Configure X.25 Virtual Circuits
Configure Neighbor Gateways
Identify Neighbor Gateways (If Any Are Present)
Identify Neighbor Gateway Reachable Networks
This chapter provides step-by-step instructions for configuring X.25 iX System Access for systems using host-based network management. This manual assumes that you are using the guided configuration capabilities of NMMGR.

Before using NMMGR to configure a link, you should complete the worksheets provided. See Chapter 5 "Preparing to Configure X.25 iX System Access" for more information on planning your configuration and filling out the configuration worksheets.

This chapter includes step-by-step instructions to help you perform the following tasks:
  • Configure the X.25 iX System Access link.
  • Configure X.25 virtual circuits.
  • Configure neighbor gateways, if there are any.
Note
NOTE: If you are configuring X.25 iX System Access on a system using PC-based network management (an OpenView workstation is part of the network), you should use the HP 3000/iX Network Planning and Configuration Guide instead of this manual to configure the X.25 link.



Identify Neighbor Gateways

Modify the Network Management Configuration File