HPlogo   Configuring and Managing Host-Based X.25 Links:
HP 3000 MPE/iX Computer Systems
> Chapter 5 Preparing to Configure X.25 iX System Access

Chapter 5 Preparing to Configure X.25 iX System Access

MPE documents

Complete PDF

 

Table of Contents

Glossary

Index

 

⇓ Page Bottom

⇑ Page Top

 

DTC PAD Profiles

Plan the Network Configuration

Table of Contents

Plan the Network Configuration
Determine X.25 iX System Access Network Characteristics
X.25 Configuration Worksheet
X.25 Virtual Circuit Configuration Worksheet
Identify Neighbor Gateways
This chapter details the information you will need before you can begin to configure X.25 iX System Access for host-based systems that will include an X.25 system-to-system link. Sample worksheets are included to ease configuration.

Hewlett-Packard recommends that you configure the datacommunications and terminal subsystem (DTS) before configuring the NS X.25 link. If you have not already done so, turn to chapters 2 and 3 in this manual for information on how to configure your system's DTCs.

If you also need to configure a point-to-point link or a LAN link, see the HP 3000/ iX Network Planning and Configuration Guide.

This chapter describes how to:
  • Plan the network configuration for X.25 iX System Access.
  • Determine network characteristics for X.25 iX System Access.
  • Identify Neighbor Gateways.

    Note
    NOTE: If you are configuring X.25 iX System Access on a system using PC-based network management (an OpenView workstation is part of the network), you should use the HP 3000/iX Network Planning and Configuration Guide instead of this manual to configure the X.25 link.



DTC PAD Profiles

Plan the Network Configuration