This chapter describes, in alphabetical order, the MPE commands related to SNA Transport. You must have MPE node manager (NM) capability to use these commands. Table 6-1 "MPE Command Summary" summarizes the functions of the commands.

Table 6-1 MPE Command Summary

Command	Function
RESUMENMLOG	Resumes NM logging after a recoverable error.
SHOWNMLOG	Displays the identification number and available space of the NM log file.
SNACONTROL AUTODIAL	Causes an SNA node's auto-dial modem to dial.
SNACONTROL START	Starts an SNA node, link-level tracing, and SNA Transport node tracing.
SNACONTROL STATUS	Displays the status of a specific SNA node.
SNACONTROL STOP	Stops an SNA node and all activity on the node.
SNACONTROL STOPSESS	Stops an LU-LU session without stopping the SNA node.
SNACONTROL TRACEOFF	Turns off link-level tracing, SNA Transport intrinsic tracing, and SNA Transport node tracing.
SNACONTROL TRACEON	Turns on link-level tracing, SNA Transport intrinsic tracing, and SNA Transport node tracing.
SNACONTROL VERSION	Identifies the software version of SNA Transport, SNA/X.25 Link, and SNA/Token Ring Link.
SWITCHNMLOG	Closes the current NM log file and creates and opens a new one.

Problem Resolution

RESUMENMLOG

Chapter 6 MPE Commands

MPE documents