|
|
Causes an SNA node's auto-dial modem to dial.
Syntax
SNACONTROL AUTODIAL;NODE=NodeName
Use
SNACONTROL AUTODIAL can be issued from a session, a job, a program, or
in break. Pressing [BREAK] has no effect on this command.
Parameter
- NodeName
Conditionally required. The name of the active SNA node you
want to cause to automatically dial. The name can be up to eight
alphanumeric characters long; the first character must be alphabetic.
If only one SNA node is active, this parameter is optional: If you do not
include it, the active node is caused to automatically dial. If
more than one node is active, this parameter is required: If you
do not include it, a list of all configured nodes is displayed, but no
node will automatically dial; you can then reissue this command with the
appropriate node name.
Description
SNACONTROL AUTODIAL causes the auto-dial modem configured for an SNA
node to dial.
To use this command, these conditions must exist:
Note that this command can be issued only after the SNA node has been
started.
Example
SNACONTROL AUTODIAL;NODE=IBMNODE
The auto-dial modem configured for node IBMNODE is caused to dial.
|