This chapter provides step-by-step instructions for configuring
X.25 iX System Access for systems using PC-based network management.
This manual assumes that you are using the guided configuration
capabilities of NMMGR.
Figure 8-1 “X.25 Link Screen Flow” shows the screen
flow for configuring X.25 screens. Screens unique to X.25 configuration
are indicated by bold boxed screens. [FUNCTION]
denotes the function key used at a screen to invoke the next screen
on the screen flow.
Figure 8-1 X.25 Link Screen Flow
Before using NMMGR to configure a link, you should complete
the worksheets provided. See Chapter 4 “Planning for Node Configuration” for more information on planning your
configuration and filling out the configuration worksheets.
This chapter includes step-by-step instructions to help you
perform the following tasks:
Begin the configuration process.
Configure an X.25 network interface.
Configure neighbor gateways.
Once the above tasks are completed, refer to Chapter 10 “Validating Network Transport and
Cross-Validating with SYSGEN” for step-by-step
instructions to help you perform the following validation tasks:
Validate the network transport configuration.
Cross-validate in SYSGEN.
 |
 |  |
 |
 | NOTE: If you are configuring X.25 iX System Access on a system
that is using host-based network management (a PC running the HP
OpenView Network Manager is not part of the network), use Configuring
and Managing Host-Based X.25 Links instead of this manual
for step-by-step configuration instructions. |
 |
 |  |
 |