Using Access Port Commands

The AP has several commands for manipulating its activities. Table A-2 “Access Port Commands” lists these commands and their functions.

Table A-2 Access Port Commands

Command	Function
`CA`	Configure system remote support modem port.
`CO`	Returns console from control mode to console mode.
`DI`	Disconnects line to remote console.
`DR`	Disables access to the system by a remote console.
`DS`	Disables display of system status line during console mode.
`ER`	Enables access by a remote console.
`ES`	Enables display of system status line during console mode.
`HE`	Displays the help screen.
`RS`	Stops all processing, initiates SPU self-test, and loads software from load device if enabled for autoboot.
`SE`	Transfers remote terminal from console/control mode to session mode.
`TA`	Initiates access port self-test.
`TC`	Transfers processor execution to operating-system-specific routine. Initiates a system soft reset.
`TE`	Sends messages (up to 80 characters) between local and remote consoles.

Technical documentation