HP 3000 Manuals HP 3000 Manuals
Using Access Port Commands
The AP has several commands for manipulating its activities. Table A-2
(*) lists these commands and their functions.
Table A-2. Access Port Commands
--------------------------------------------------------------------------------------------
| | |
| Command | Function |
| | |
--------------------------------------------------------------------------------------------
| | |
| CA | Configure system remote support modem port. |
| | |
--------------------------------------------------------------------------------------------
| | |
| CO | Returns console from control mode to console mode. |
| | |
--------------------------------------------------------------------------------------------
| | |
| DI | Disconnects line to remote console. |
| | |
--------------------------------------------------------------------------------------------
| | |
| DR | Disables access to the system by a remote console. |
| | |
--------------------------------------------------------------------------------------------
| | |
| DS | Disables display of system status line during console mode. |
| | |
--------------------------------------------------------------------------------------------
| | |
| ER | Enables access by a remote console. |
| | |
--------------------------------------------------------------------------------------------
| | |
| ES | Enables display of system status line during console mode. |
| | |
--------------------------------------------------------------------------------------------
| | |
| HE | Displays the help screen. |
| | |
--------------------------------------------------------------------------------------------
| | |
| RS | Stops all processing, initiates SPU self-test, and loads software |
| | from load device if enabled for autoboot. |
| | |
--------------------------------------------------------------------------------------------
| | |
| SE | Transfers remote terminal from console/control mode to session mode. |
| | |
--------------------------------------------------------------------------------------------
| | |
| TA | Initiates access port self-test. |
| | |
--------------------------------------------------------------------------------------------
| | |
| TC | Transfers processor execution to operating-system-specific routine. |
| | Initiates a system soft reset. |
| | |
--------------------------------------------------------------------------------------------
| | |
| TE | Sends messages (up to 80 characters) between local and remote |
| | consoles. |
| | |
--------------------------------------------------------------------------------------------