HP 3000 Manuals

System Startup, Configuration, and Shutdown Reference Manual

Using the AP Help Facility 

Obtain online help by entering either HELP or the abbreviated command,
HE.

The command issues the following display:

     CM>HELP 

                Access Port Revision xxx  m.d.y 

     CA  Configure system remote support modem port.
     CO  Enter console mode.
     DI  Disconnect line to remote console terminal.
     DR  Disable access by a remote console terminal (enables session
           access).
     DS  Disable display of system status line during console mode.
     ER  Enable access by a remote console terminal (disables session
           access).
     ES  Enable display of system status line during console mode.
     HE  Display this screen.
     RS  Stop all processing, initiate SPU Self-Test, load software
           from load device if enabled for autoboot.
     SE  Transfer remote terminal from console/control to session mode.
     TA  Initiate Access Port Self-Test.
     TC  Transfer processor execution to operating system specific routine.
     TE  Send message between local and remote console terminals.

In the preceding display, xxx is the number of the revision of the
operating firmware contained on the AP and m.d.y is the month, day and
year the firmware revision was released.  These identifications are
necessary to manage ROM updates in the field if they become necessary.

MPE/iX 5.0 Documentation