HP 3000 Manuals HP 3000 Manuals
R[ESET]
To clear hardware and software associated with a logical device number,
physical port, serial interface card, or DTC so that a new session or job
can be started on each port.
Security level: 1 for DTC; 2 for remaining functions.
Syntax
________________________________________________________________________
| |
| |
|R[ESET] |
________________________________________________________________________
Description
After the RESET command is entered, the following prompt is printed on
the terminal:
(reset)
Ldev #
POrt #,#,#
SIc #,# (multiplexer card in DTC)
DTc #
(carriage return to exit) ?
These are the subcommands that can then be entered. The following pages
describe each of these options.
If you press Enter instead of one of the subcommands, you will be
returned to the major prompt and may then enter another TermDSM command.
Some port/ldev problems can not be fixed with ldev or port resets. If a
port is still unusable after a reset, consider using RESET SIC. Note that
this will affect all users (up to eight) on that card. Finally, if the
RESET SIC is also unsuccessful, then the entire DTC should be reset.
Note that this will affect all the users on the DTC (up to 48).