HP 3000 Manuals HP 3000 Manuals
RJE/XL System Modules
This section identifies those RJE/XL modules that must be installed.
RJE.PUB.SYS The CM program code for RJE/XL which acts as an
entry point to the program.
PSIRJE00.PUB.SYS This is the file name of the RJE BSC download
firmware the version of which is in the file
label.
RJE/XL System Library RJE/XL termination procedure, a compatibility
(SL) Segments mode procedure (DCL'AFT'11) which is installed
in the system SL.
Trace formatter, the native mode procedures
must be installed in the system SL.
* SUBSYS37FMTVERS: A procedure that provides
the version of the trace formatter.
* The trace formatter procedure.
RJE/XL Native Library RCS NM procedures that are native mode RJE/XL
(NL) Segments communications subsystem procedures that must
reside in the system NL are as follows:
ROPEN RCLOSE
RREAD RWRITE
RCHECK RGETINFO
RCONTROL RJE_IOWAIT_COMPLETOR
PRINT_LINE_INFO
RJE/XL BSC driver which is the RJE/XL
pass-through driver that is a port procedure
and must be installed in the system NL.
* WANRJEVERS: The NL procedure that returns
the version of the NL driver.
WAN module configurator which is the version of
the WAN module configurator that supports
RJE/XL and must be installed in the system NL.
* WANMCVERS: The NL procedure that returns
the version of the WAN module configurator.
* WAN_MODULE_CONFIG: A procedure that looks
into NMMGR for the link; then configures
the link according to the information
provided in NMMGR.
* WAN_KILL_MODULE: Terminates the link.
Dump Surrogate
* WANDUMPSURRVERS: The NL procedure that
returns the version of the diagnostic
driver.