CM Emulator & OCT (Subsystem 188)
MPE documents | |
 Complete PDF | |
| Table of Contents | |
| E0701 Volume II | |
| E0300 Volume I | |
| E0300 Volume II | |
| E0300 Volume III ♥ | |
| E0394 Volume I | |
| E0796 Volume II | |
| E0494 Volume III |
- 1
- MESSAGE
The input node is too low. (CMNODES ERROR 1)
- CAUSE
Bad input parameter.
- ACTION
No harm done. Function returns false.
- 2
- MESSAGE
The input node is too high. (CMNODES ERROR 2)
- CAUSE
Bad input parameter.
- ACTION
No harm done. Function returns false.
- 3
- MESSAGE
Invalid node return from debug. (CMNODES ERROR 3)
- CAUSE
Bad input parameter.
- ACTION
No harm done. Function returns false.
- 201
- MESSAGE
The code segment loaded emulated because translation is bad.
- CAUSE
Bad translation.
- ACTION
Retranslate with a good OCT.
- 202
- MESSAGE
The code segment loaded emulated because translation is bad.
- CAUSE
Bad translation.
- ACTION
Retranslate with a good OCT.
- 203
- MESSAGE
The code segment loaded emulated because OCT is for another system.
- CAUSE
The system and OCT versions are not compatible.
- ACTION
Retranslate with the appropriate OCT version.
- 204
- MESSAGE
The code segment loaded emulated because translation is bad.
- CAUSE
Bad translation.
- ACTION
Retranslate with a good OCT.
- 205
- MESSAGE
The code segment loaded emulated because FFILEINFO failed.
- CAUSE
Unknown.
- ACTION
Call your Hewlett-Packard Representative.
- 501
- MESSAGE
OCT error occurred.
- 502
- MESSAGE
! is an invalid code segment name.
- 503
- MESSAGE
! is an invalid code segment number.
- 504
- MESSAGE
Failed to open file !.
- 505
- MESSAGE
! is an invalid input file.
- 506
- MESSAGE
! is an unknown argument name.
- 507
- MESSAGE
Argument ! is specified in an invalid manner.
- 508
- MESSAGE
Attempt to read beyond PB.
- 510
- MESSAGE
PLABEL ! is out of bounds.
- 550
- MESSAGE
OCT internal error occurred.
- CAUSE
Internal error.
- ACTION
Call your Hewlett-Packard Representative.
- 551
- MESSAGE
An error occurred executing CI command.
- 552
- MESSAGE
Invalid addressing mode.
- 553
- MESSAGE
Invalid data type on stack.
- 554
- MESSAGE
Double operand missing HOLE-REG.
- 555
- MESSAGE
The maximum register usage has been exceeded.
- 556
- MESSAGE
An invalid register is specified.
- 557
- MESSAGE
Trap entry was not made.
- 558
- MESSAGE
Unable to decode CM instruction.
- 559
- MESSAGE
A TEMP REG has been clobbered.
- 560
- MESSAGE
Trap entry was made but not PUT.
- 561
- MESSAGE
An undefined block label is specified.
- 562
- MESSAGE
An unknown INST type was encountered.
- 563
- MESSAGE
An invalid BRANCH target is specified.
|
CM Debugger (Subsystem 169) |
CM Support Routines (Subsystem 154) |