The Security String(s) Configuration screen (#110) supplies
the security string required by the dial ID protocol for the node
you are configuring. Note that the security string is not required
if dial ID protocol is not enabled. This screen, shown in Figure 12-7 “Security String(s) Configuration
Screen”, is displayed if you press
the [Go to SECURITY] function key at the preceding
Dial ID Protocol Configuration screen (Figure 12-6 “Dial ID Protocol Configuration Screen”). It is also displayed when you type:
@NETXPORT.NI.NIname.PROTOCOL.DIAL.SECURITY
in the command window of any screen and press the [Enter]
key, where NIname is the configured gateway
half NI.
Figure 12-7 Security String(s) Configuration
Screen
Press the [Save Data] function key to transfer
the data displayed on the screen to the configuration file you are
creating or updating. Verify that the data record has been created
by checking that the Data flag is set to Y.
Fields
- Configured security strings
Enter the security string that remote nodes must
use to gain dial link access to the node you are configuring. The
string can contain up to eight alphanumeric characters, left justified,
with no embedded blanks.
Default value: HP
Related screen: