 |
» |
|
|
|
This section describes how to determine your system configuration
group. The factory
System Load Tape (SLT)
does not contain a default I/O
configuration.
During an installation, you must specify
the appropriate factory configuration group when booting the system
immediately after installing the factory SLT. Listing the system
configuration uses the off-line diagnostic
tool, Mapper. To get help using
MAPPER,
type help at the MAPPER
prompt, and see Figure 5-1 “Sample Listing MAPPER Output” for
a sample listing. To list the system configuration: Check that all
hardware
peripherals
are attached and powered
on. Start ODE. Display hardware configuration. The figure on the following page is a sample of a MAPPER
display. Record the I/O configuration for your system. Find the MPE/XL Model String. Then refer to Appendix B “Configuration Tables” for the configuration
group name for your HP 3000 model in the SCSI, HP-IB, or HP-FL (Alink)
column. For example, for a Model 995, the SCSI group is CONFG995.
It is very important to have the exact group name. Check carefully
for numbers zero and 1 and letters O and I. Exit mapper. Figure 5-1 Sample Listing MAPPER Output STARTING EXECUTION OF MAPPER Processor Identification: Hardware Model: 280H, Revision: 0 Software Model: 4H, Revision: 0 Hardware ID: 0, Software ID: 142828241 (unsigned decimal) Software Cap: 0x100000061 MPE/XL Model String: 957SX Processor Board Revisions: CPU - CPU Chip: 3 System Controller: 3 PDC - Processor Dependent Code 1.5 Cache and TLB sizes: Instruction Cache: 64 K bytes, Instruction TLB: 96 entries Data Cache: 64 K bytes, Data TLB: 96 entries Co-processors: None installed I/O Configuration: Type HW SW Revisions Path Component Name ID Mod Mod Hdwr Firm 8 CIO Adapter 8H 5H 10H 0 0 8.0 HP-IB card 2H - - 6 2912 16 CIO Adapter 8H 5H 10H 0 0 16.0 HP-IB card 2H - - 6 2912 52 HP-IB SCSI 4H 14H 39H 0 0 Resetting SCSI Bus ... 52.0.0 HPC1503 (X) /HPC1520B DDS tape - - - - 1009 52.2.0 HPA1999A CD-ROM drive - - - - 0272 52.5.0 HPC3010M1 disc drive - - - - 0B04 52.6.0 HPC2247M1 disc drive - - - - 0B04 56 HP-PB LAN/Console 2H 14H 60H 0 0 62 Processor 0H 280H 4H 0 0 63 Memory (128 M bytes) 1H 14H 9H 0 0 Slot 1A - 32M Slot 1B - 32M Slot 5A - 32M Slot 5B - 32M Resetting the Boot Device . . . Done. RUN COMPLETED. ODE>exit ISL>
|
Listing the System Configuration
completed. Go to the next section on your checklist.
|