HP 3000 Manuals HP 3000 Manuals
Running Tests with Commands
To run the Resource Sharing diagnostic tests with
commands:
1. At the MPE prompt, enter:
PPCDIAGC.PPC.SYS
2. Enter any of the diagnostic commands (listed in Table 7-1) at this
prompt:
PPCDIAGC>
Table 7-1. Command Summary Table
--------------------------------------------------------------------------------------------
| | |
| To run the... | At the PPCDIAGC> prompt, enter... |
| | |
--------------------------------------------------------------------------------------------
| | |
| Verification Test | VERIFY RESSHR |
| | |
| | -or- |
| | |
| | SPECIAL RESSHR 1 |
| | |
| | When the test is complete, a composite version number is |
| | displayed, and all component files and versions are listed, as |
| | shown in the description of the Verification Test. |
| | |
--------------------------------------------------------------------------------------------
| | |
| Verification Test | SPECIAL RESSHR 3 |
| with only a summary | |
| of results | A summary of the results of the Verification Test will be |
| | displayed when the test is finished. |
| | |
--------------------------------------------------------------------------------------------
| | |
| Go/No Go Test | GONOGO RESSHR |
| | |
| | -or- |
| | |
| | SPECIAL RESSHR 2 |
| | |
| | The screen shows the status of each subtest when the test |
| | completes. |
| | |
--------------------------------------------------------------------------------------------
| | |
| CHKDISC Test | SPECIAL RESSHR 4 |
| | |
| (Validation Test) | A summary of the results is displayed when the test is finished. |
| | |
--------------------------------------------------------------------------------------------
| | |
| Table Utilization | SPECIAL RESSHR 5 |
| Test | |
| | The results are displayed when the test is finished. |
| | |
--------------------------------------------------------------------------------------------
| | |
| Single test with | This runs a single test using commands and immediately exits the |
| commands | Host Diagnostic Interface. |
| | |
| Enter this at the MPE | RUN PPCDIAGC.PPC.SYS;INFO="command" |
| prompt. | |
| | where command is the command to run the diagnostic test. |
| | |
--------------------------------------------------------------------------------------------