HP 3000 Manuals HP 3000 Manuals
Phase D. Configuring Host and Remote Databases At this point, you're ready to configure the IMAGE databases your PC users need to access. Since Phase C took you back to MPE, you must first re-enter the Administrator Utility. Re-entering the Administrator Utility --------------------------------------------------------------------------------------------- | | | | What You Do | What Happens | | | | --------------------------------------------------------------------------------------------- | | | | D-1. Run the Administrator Utility, either | | | by using the UDC command ADMIN, or by | | | typing RUN ADMIN.PPC.SYS and pressing | | | Return. | | | | | | If you've added a lockword to the file, | The Entry screen appears. | | you'll be prompted for it. Type it in and | | | press Return. | | | | | --------------------------------------------------------------------------------------------- | | | | D-2. Type your user name in the User field | The Administrator Utility Main Menu | | and your password in the User Password | appears. | | field, then press Enter. | | | | | --------------------------------------------------------------------------------------------- Adding IMAGE Databases --------------------------------------------------------------------------------------------- | | | | What You Do | What Happens | | | | --------------------------------------------------------------------------------------------- | | | | D-3. Type AIMD in the Go to screen field | The Add IMAGE Database (AIMD) screen | | and press Enter. | appears. | | | | --------------------------------------------------------------------------------------------- | | | | D-4. Type a database name, the MPE group | The definition of the database is added to | | and account it resides in, the remote | the data dictionary. | | system name (if it's not on the host), the | | | database password, and the open mode (if | | | different from the default), then press | | | Enter. | | | | | --------------------------------------------------------------------------------------------- | | | | D-5. Repeat Step D-4 for each database you | The Administrator Utility adds the | | want to configure. | definition of each database to the data | | | dictionary. | | | | --------------------------------------------------------------------------------------------- | | | | D-6. Choose Done f8. | The IMAGE Database Menu appears. | | | | | If you don't want to check your database | | | configuration, skip to Phase E. | | | | | --------------------------------------------------------------------------------------------- Checking Configuration --------------------------------------------------------------------------------------------- | | | | What You Do | What Happens | | | | --------------------------------------------------------------------------------------------- | | | | D-7. Choose List All Database f5. | The List IMAGE Databases screen appears. | | | This screen lists the names of all | | | configured databases, the MPE group and | | | account the databases reside in, and the | | | remote system (if any) where the databases | | | are located. | | | | | | Secondary DBAs will see only the names of | | | the databases under their control. | | | | | If any databases need to be added, use the | | | Add IMAGE Database (AIMD) screen to do so. | | | If any databases are not defined correctly, | | | use the Change IMAGE Database (CIMD) screen | | | to correct the definition. | | | | | --------------------------------------------------------------------------------------------- | | | | D-8. Choose Done f8. | The IMAGE Database Menu appears. | | | | ---------------------------------------------------------------------------------------------