HP 3000 Manuals HP 3000 Manuals
Verifying the Setup
The following steps allow you to check and see that your terminals,
printers, and disk drives have been installed correctly.
1. Test all of the terminals connected to your system.
a. Turn on each terminal.
b. After the screen has warmed up, press Return once or twice.
The logon prompt should appear on the screen. This prompt
indicates that the terminal is ready for a user logon (the HELLO
command).
If the prompt is not displayed on all of the terminals, refer to
the chapter "Troubleshooting" in this manual.
2. Test all of the printers connected to your system.
a. Turn on each printer and return to the system console.
b. From the console, enter the following commands:
:FILE LP;DEV=113Return
:LISTF@;*LPReturn
Your printers should print the contents of the files that
are in the group that you are logged on to. If
your printers did not print, refer to the chapter
"Troubleshooting" in this manual.
3. Test your external disk drives by entering the following command:
:DSTAT ALL
The volume names of each of your disk drives should be displayed
on the screen.