HP 3000 Manuals HP 3000 Manuals
TAPE
The TAPE command displays the current tape drive's logical device number
(LDEV) or selects another tape drive as the current tape drive.
If the LDEV parameter is omitted, the current tape drive's LDEV is
displayed. If the LDEV parameter is supplied, that LDEV becomes the
current tape drive. The LDEV must have been configured as a tape drive.
Task
Displays the current tape drive's LDEV or selects another LDEV as the
current tape drive.
Capability
No special capability required.
Syntax
TAPE [[LDEV=] ldev ]
Parameter
ldev A number from 1 to 100 specifying the logical
device number of the tape drive that will become
the current tape drive. Optional.
Example
This example shows how to change the current tape drive's LDEV by using
the TAPE command.
______________________________________________
| |
| |
| discutil> TAPE 15 |
| |
| *Note: TAPE DRIVE SWITCHED TO LDEV 15 |
| |
______________________________________________