HP 3000 Manuals

Ch 69. Serial Disk [ MPE/iX Error Messages Manual Volume III ] MPE/iX 5.0 Documentation


MPE/iX Error Messages Manual Volume III

Chapter 69  Serial Disk 

(SDERR) 

--------------------------------------------------------------

---------------------------------------------------------------

1            MESSAGE    LDEV #\ Cannot access serial disc using system
                      buffers (SDERR 1)

---------------------------------------------------------------

2            MESSAGE    LDEV #\ ATTACHIO failure - reading/writing disc
                      label (SDERR 2)

---------------------------------------------------------------

3            MESSAGE    LDEV #\ Fatal error - serial disc interface
                      disabled (SDERR 3)

---------------------------------------------------------------

4            MESSAGE    LDEV #\ Invalid length in WRITE'BUFFER (internal
                      error) (SDERR 4)

---------------------------------------------------------------

5            MESSAGE    LDEV #\ End of tape detected (SDERR 5)

---------------------------------------------------------------

6            MESSAGE    LDEV #\ ATTACHIO failure - reading DTT/DSCT
                      (SDERR 6)

---------------------------------------------------------------

7            MESSAGE    LDEV #\ Pack overflow - probably ignored EOT
                      (SDERR 7)

---------------------------------------------------------------

8            MESSAGE    LDEV #\ ATTACHIO failure - writing DTT/DSCT
                      (SDERR 8)

---------------------------------------------------------------

9            MESSAGE    LDEV #\ Contig and non-contig data mixed in
                      RECBUFF (SDERR 9)

---------------------------------------------------------------

10           MESSAGE     LDEV #\ Can't call FINDSDISCGAP unless file is
                      open (SDERR 10)

---------------------------------------------------------------

11           MESSAGE    LDEV #\ FINDSDISCGAP - Block number must be > 0.
                      (SDERR 11)

---------------------------------------------------------------

12           MESSAGE    LDEV #\ ATTACHIO failure - assigning alternate
                      tracks (SDERR 12)

---------------------------------------------------------------

13           MESSAGE    LDEV #\ ATTACHIO failure - reading Gap Table
                      (SDERR 13)

---------------------------------------------------------------

14           MESSAGE    LDEV #\ Invalid control code (SDERR 14)

---------------------------------------------------------------

15           MESSAGE    LDEV #\ ATTACHIO failure - writing Gap Table
                      (SDERR 15)

---------------------------------------------------------------

16           MESSAGE    LDEV #\ Attempted to write on protected drive
                      (SDERR 16)

---------------------------------------------------------------

17           MESSAGE    LDEV #\ Out of sync with Gap Table while reading
                      (SDERR 17)

---------------------------------------------------------------

18           MESSAGE    LDEV #\ Gap Table overflow - probably ignored EOT
                      (SDERR 18)

---------------------------------------------------------------

19           MESSAGE    LDEV #\ Too many EOFs for this disc (SDERR 19)

---------------------------------------------------------------

20           MESSAGE    LDEV #\ No spare blocks available.  (SDERR 20)

---------------------------------------------------------------

21           MESSAGE    LDEV #\ Uninitialized media.  (SDERR 21)

---------------------------------------------------------------

22           MESSAGE    LDEV #\ Attempted to read past end of data (SDERR
                      22)

---------------------------------------------------------------

23           MESSAGE    LDEV #\ Buffer pointer exceeds buffer (internal
                      error) (SDERR 23)

---------------------------------------------------------------

24           MESSAGE    LDEV #\ Attempted a Backspace File while at Load
                      Point.  (SDERR 24)

---------------------------------------------------------------

25           MESSAGE    LDEV #\ Attempted to space backward at Load
                      Point.  (SDERR 25)

---------------------------------------------------------------

26           MESSAGE    LDEV #\ Not a serial disc (disc label or internal
                      error) (SDERR 26)

---------------------------------------------------------------

27           MESSAGE    LDEV #\ Runaway serial disc (access beyond end of
                      data) (SDERR 27)

---------------------------------------------------------------

28           MESSAGE    LDEV #\ Access beyond end of Gap Table (internal
                      error) (SDERR 28)

---------------------------------------------------------------

29           MESSAGE    LDEV #\ ATTACHIO failure - writing data.  (SDERR
                      29)

---------------------------------------------------------------

30           MESSAGE    LDEV #\ Leading/trailing lengths don't match
                      (corrupt disc)   (SDERR 30)

---------------------------------------------------------------

31           MESSAGE    LDEV #\ Tried to overfill SDISC buffer (internal
                      error) (SDERR 31)

---------------------------------------------------------------

32           MESSAGE    LDEV #\ ATTACHIO failure - reading data (SDERR
                      32)

---------------------------------------------------------------

33           MESSAGE    LDEV #\ Corrupt Defective Track/Sector Table
                      (SDERR 33)

---------------------------------------------------------------

34           MESSAGE    LDEV #\ Not enough memory for data buffers.
                      (SDERR 34)

---------------------------------------------------------------

35           MESSAGE    LDEV #\ Device not allocated or LDTX corrupted
                      (SDERR 35)

---------------------------------------------------------------

36           MESSAGE    LDEV #\ Extra data segment too small for this
                      device.  (SDERR 36)

---------------------------------------------------------------

37           MESSAGE    LDEV #\ Attempted to write past EOT without
                      capability (SDERR 37)

---------------------------------------------------------------

38           MESSAGE    LDEV #\ ATTACHIO failure - loading or unloading
                      (SDERR 38)

---------------------------------------------------------------

39           MESSAGE    LDEV #\ Request aborted externally.  (SDERR 39)

---------------------------------------------------------------

40           MESSAGE    LDEV #\ "Write" capability denied by operator
                      (SDERR 40)

---------------------------------------------------------------

41           MESSAGE    LDEV #\ System or device powerfail.  (SDERR 41)

---------------------------------------------------------------

42           MESSAGE    LDEV #\ ATTACHIO failure - setting IR on/off
                      (SDERR 42)

---------------------------------------------------------------

43           MESSAGE    LDEV #\ Required GPTMOD parameter missing.
                      (SDERR 43)

---------------------------------------------------------------



MPE/iX 5.0 Documentation