HP 3000 Manuals

System Debug Reference Manual

NM 

Enters native mode (nmdat / nmdebug).  See the CM command.

Syntax 

     NM

The command switches from CM (cmdat/cmdebug) to NM (nmdat/nmdebug).  If
the windows are on, the screen is cleared and the set of windows enabled
for nmdebug are redrawn.  The command also sets several environment
variables.  The variables affected and their new values are shown below:

     ENV  MODE     "NM"
     ENV  INBASE   NM_INBASE
     ENV  OUTBASE  NM_OUTBASE

Parameters 

none

Examples 

     %cmdebug > nm 
     $nmdebug >

Switch from cmdebug to nmdebug.

Limitations, Restrictions 

none


CAUTION  The output format of all System Debug commands is subject to
         change without notice.  Programs that are developed to
         postprocess System Debug output should not depend on the exact
         format (spacing, alignment, number of lines, uppercase or
         lowercase, or spelling) of any System Debug command output.

MPE/iX 5.0 Documentation