HP 3000 Manuals

Troubleshooting Terminal, Printer, and Serial Device Connections

Starting TermDSM 

To use TermDSM, enter the SYSDIAG command at the MPE XL prompt (:).  The
Diagnostic User Interface prompt appears:

     DUI>

From this prompt, many diagnostics can be run.  Type HELP to see a list.
To run TermDSM, enter:

     DUI>RUN TERMDSM 

The following information will appear on the terminal.

     ***********************************************************
     ******                    TERMDSM                    ******
     ******                                               ******
     ******       (c) Hewlett-Packard Corporation 1987    ******
     ******            Version A.00.00.013                ******
     ******                                               ******
     ******               Catalog AM.027                  ******
     ***********************************************************

     Welcome, Today is TUE, SEP 22, 1987 at 11:57 AM

     Your system has these Distributed Terminal Controllers:

     DTC      Network
     Number    Address              Name
     ------  ------------  ---------------------
     1       08000900180A      BIOLAB
     2       080009001808      MARKETING
     3       080009001234      TIMESHAREROOM

     Use this number as the "DTC number" in Termdsm commands.

     Comment   DIag   DTc   DUmp   Help   Reset   STatus   EXIt?

The last line is the TermDSM prompt.  Notice that the prompt lists all
the possible commands that you can enter.  The capital letters listed are
the abbreviations for each command.  You can stop the looping of a
diagnostic function by entering CTRL-Y (looping is terminated after the
current loop is completed).

MPE/iX 5.0 Documentation