HP 3000 Manuals HP 3000 Manuals
Step 6: Determine Migration Options The migration utility, MIGRATE, allows you to do a full migration which migrates all volumes and the bindery files at once, or a partial migration which migrates a single volume at a time You must migrate the system (SYS or SYSVOL) volume first. Figure 5-1 shows the menu options for the migration utility. In addition, you can modify migration options using command line options, or using the Menu options (before selecting a full or partial migration). When to Use Full Migration If you only have one NetWare volume, use full migration. When to Use Partial Migration If you have multiple volumes, and want to migrate them one at a time use partial migration. If you decide not to migrate a particular volume of data, use partial migration.Figure 5-1. MIGRATE Utility Screen Map Command Line Options The command line options are entered as follows: :migrate "-option1 option2..." For example, to select log to a file (l) and purge old files (p) you can enter either: :migrate "-lp" or, :migrate "-l -p" Migration Utility Options Table 5-4 lists the command-line options you can use. Refer to the section, "Migration Utilities" later in this chapter for more information on migration options. Table 5-4. Migrate Command Options -------------------------------------------------------------- | | | | Opton | Description | | | | -------------------------------------------------------------- | | | | -v | Verbose: Displays log information during the | | | migration process. | | | | -------------------------------------------------------------- | | | | -d | Debug: More information than verbose is | | | displayed. Useful for troubleshooting. | | | | -------------------------------------------------------------- | | | | -l | Log information is output to a file instead of | | | a terminal. The file created is: | | | MIGLOG.NETWARE.SYS. | | | | -------------------------------------------------------------- | | | | -n | Never purge 3.01B files. The default (if you | | | do not use -n), is to automatically purge old | | | files if therre is insufficient disk space. | | | | -------------------------------------------------------------- | | | | -p | Always purge 3.01B files. | | | | -------------------------------------------------------------- Menu Options If you want to use the MIGRATE utility menus to select these options, do the following before selecting full or partial migration: 1. Log into the system: :hello manager.sys,netware 2. Make sure NetWare has been stopped: :nw status NWIXCTRL: Doing "NW STATUS" NWIXCTRL: NetWare/iX version 3.11a is DOWN 3. Run the migration utility: :migrate 4. From the Main menu, select: Table 5-5. ------------------------------------------------------------ | | | | 3. | Migration Utilities | | | | ------------------------------------------------------------ | | | | 1. | Options | | | | ------------------------------------------------------------ 5. The Options menu is displayed. To change an option, enter the number of the option. 6. Return to the Main menu by typing r. 7. Proceed with your migration as described below.
![[]](../../pic3k/M016068/FFN83c50.gif)