HP 3000 Manuals HP 3000 Manuals
Command and Command Acknowledgment Messages (PTMSG and PTCOMACK)
The following command and command acknowledgment messages will appear on
Pass Thru devices, requesting that you enter commands, or requesting or
acknowledging printer key entry.
---------------------------------------------------------------------------------------
PTCOMACK 119 MESSAGE Request entered for nau. (PTCOMACK 119)
CAUSE The command was processed or the key you entered was sent
to the printer. This message does not necessarily
indicate that the printer has executed the request.
ACTION None.
---------------------------------------------------------------------------------------
PTCOMACK 120 MESSAGE Nau not accepting commands. (PTCOMACK 120)
CAUSE The Network Addressable Unit listed was not in a state to
receive commands.
ACTION Check your request and enter the command or key again.
-----------------------------------------------------------------------------------------
PTMSG 121 MESSAGE Enter PA1 or PA2 for printer nau. (PTMSG 121)
CAUSE The PA1 or PA2 key for your LU.T1 printer must be
entered.
ACTION Enter the PA1 or PA2 key for the printer with the Network
Addressable Unit (NAU) listed in the message. The
message that appears on the console will look something
like this:
14:25/27/Enter PA1 or PA2 for printer nau. (PTMSG 121)
In this example, 14:25 is the current time; 27 is the
Process Identification Number (PIN) for SNA IMF. To enter
the PA1 or PA2 key, type the following reply at the
console:
REPLY n, key
where n is the PIN of the console message and key is the
PA1 or PA2 key.
Example: REPLY 27, PA1
-----------------------------------------------------------------------------------------
PTMSG 124 MESSAGE Nau is in an LU.T n session. (PTMSG 124)
CAUSE You entered the SHOW command. This message informs you
that the NAU name in the message is in an active LU-LU
session.
ACTION Use the NAU name that appears in the message to SEND
LU.T1 commands to the Pass Thru process in an LU.T1
session. You may send the SET PAGE command to a Pass
Thru process in an LU.T3 session. Pass Thru processes in
LU.T2 sessions will not receive command input.
---------------------------------------------------------------------------------------
PTMSG 126 MESSAGE Nau is opened for an LU.T n session. (PTMSG 126)
CAUSE You entered the SHOW command. This message informs you
that the NAU named in the message has been powered on for
an LU-LU session of the type listed in this message.
ACTION Use the NAU name that appears in the message to send
printer commands or adjust printer page length. See
"Entering Printer Commands and Adjusting Page Length," in
chapter 6 of this manual.