HPlogo MPE/iX System Utilities Reference > Chapter 26 SYSMAP

Operation

MPE documents

Complete PDF
Table of Contents
Index

To invoke SYSMAP enter: 

   SYSDIAG
   DUI> RUN SYSMAP
SYSMAP is part of the Online Diagnostics Subsystem. To use this utility, start the diagnostic subsystem by entering SYSDIAGand at the DUI> prompt, enter RUN SYSMAP.

Once you are in the SYSMAP subsystem, you can choose one of three basic map options: 

   ENTER MAP> CPUMAP
   ENTER MAP> MEMMAP
   ENTER MAP> IOMAP
If you choose CPUMAP the system displays the following for each CPU: hardware model and revision number, software model and revision number and slot number.

If you choose MEMMAP the system responds by listing memory controller's and arrays, slot numbers, hard physical addresses and memory size.

If you choose IOMAP the system responds by presenting the IOMAP> prompt. At this prompt you may choose one of three responses: 

   IOMAP> GENERAL
   IOMAP> CLASS
   IOMAP> STEPPING

  • GENERAL displays a general map of the I/O configuration.

  • CLASS maps all devices in the device class you specify.

  • STEPPING displays all system hardware configurations or all configurations from a specific physical address on down.

Additional Discussion

Precision Architecture: HP 3000/9xx & HP 9000/8xx Online Diagnostics Subsystem Utilities Manual.



Chapter 26 SYSMAP

Chapter 27 tic