GETDSEG
MPE documents | |
 Complete PDF | |
| Table of Contents | |
| Index | |
| Edition 7 E0701 ♥ | |
| Edition 7 E0300 | |
| Edition 6 E0195 |
 |
NOTE: Data segment management (DS) intrinsics are not recommended for use in native mode programming environment. Use of DS intrinsics in NM degrades your program's performance. |
Syntax
U16 I16 U16V
GETDSEG (index, length, id);
Parameters
- index
16-bit unsigned integer by reference (required)
Returns the index of the extra data segment assigned by the operating system. When GETDSEG is called in user mode, index is a logical index of the assigned data segment; if an error is found, index is set to %2000-%2004. When GETDSEG is called in privileged mode, index is the actual data segment table (DST) entry number assigned for the data segment.
- length
16-bit signed integer by reference (required)
Passes the user-specified maximum size, in half words, of the newly created data segment. If the data segment already exists, length returns the maximum size, in half words, of the data segment.
- id
16-bit unsigned integer by value (required)
Passes the identity that declares the extra data segment shareable between other processes in the job/session, or private to the calling process. For a shareable extra data segment, specify id as a nonzero value. If an extra data segment with the same identification already exists, it is made available to the calling process; otherwise, a new extra data segment, shareable within the job/session, is created with id. For a private extra data segment, specify an id of zero.
Operation Notes
The number of extra data segments that can be requested, and the maximum size allowed these segments, is limited by parameters specified when the system is configured. When an extra data segment is created, the GETDSEG intrinsic returns a logical index number to the process. This index number is assigned by the operating system and allows the process to reference the extra data segment in later intrinsic calls. Assign the extra data segment to an identity that either allows other processes in the job or session to share the extra data segment, or that declares it private to the calling process. If the extra data segment is shareable, other processes can obtain its index (through GETDSEG) and use this index to reference the extra data segment. Thus, the index is a local name that identifies the extra data segment throughout any process that obtained the index with the GETDSEG call. The index does not need to be the same value in all processes sharing the extra data segment. However, the identity is a job-wide or session-wide name that permits any process to determine the index of the extra data segment. If GETDSEG is called in user mode, the extra data segment is initially filled with zeros. When GETDSEG is called in user mode, all subsequent calls to intrinsics that use index must be in user mode. When GETDSEG is called in privileged mode, all subsequent calls to intrinsics that use index must be in privileged mode. When a data segment is created through GETDSEG, sufficient virtual space is allocated by the system to accommodate the original length of the data segment. This virtual space is allocated in increments of 512 half words. For example, creation of an extra data segment with a length of 600 half words results in the allocation of 1024 half words of virtual space.
Condition Codes
| CCE (2) | Request granted. A new extra data segment was created. | ||||||||||||
| CCG (0) | Request granted. An extra data segment with this identity exists already. | ||||||||||||
| CCL (1) | Request denied. The following values are returned in
index:
|
Related Information
| Intrinsics | ALTDSEG, DMOVIN, DMOVOUT, FREEDSEG, SWITCHDB |
| Manuals | Introduction to MPE XL for MPE V Programmers |
|
GENMESSAGE |
GETINFO |