Running NMDUMP

1. Type

   :RUN NMDUMP.PUB.SYS

2. Enter either (1) logging or (2) tracing.

3. Enter the ID number for each subsystem you want to format. Use a comma to separate each number. (Default = ALL.)

   NOTE: ID numbers can be used as parameters with NMMAINT.

4. Change the default (NO) to (YES) if you would like to enter subsystem options. (NMDUMP will set the default options if (NO) is entered.)

   1. Enter the subsystem ID for the options you want to change.

   2. Enter the number of the option or <CR> to select the current options.

5. Enter the input log or trace file name. (Must already exist on the system.)

   FILENAME.GROUP.ACCOUNT

6. Enter the output log or trace file name. Default = $STDLIST. (Must not yet exist on the system.)

   FILENAME.GROUP.ACCOUNT

7. Change the default (NO) to (YES) if you want to specify a time range.

   1. Enter the starting time.

      Respond Y or N if the displayed time is correct.

   2. Enter the finishing time.

      Respond Y or N if the displayed time is correct.

8. Press [CTRL]Y when you have completed your responses. (NMDUMP will then give you a chance to re-enter the values.)

9. Use the default (NO) if you are satisfied with your entered values. NMDUMP then formats the logging or tracing information you specified.