CIPER Devices
MPE documents | |
 Complete PDF | |
| Table of Contents | |
| E0701 Volume II | |
| E0300 Volume I | |
| E0300 Volume II | |
| E0300 Volume III ♥ | |
| E0394 Volume I | |
| E0796 Volume II | |
| E0494 Volume III |
- 1
- MESSAGE
Ldev #\ not ready; check cable connections. (CIPER 1)
- 2
- MESSAGE
Ldev #\ has been powered up or reset. (CIPER 2)
- 3
- MESSAGE
Ldev #\ has been placed off-line. (CIPER 3)
- 4
- MESSAGE
Ldev #\ has been placed on-line. (CIPER 4)
- 5
- MESSAGE
Ldev #\ reports out of paper; please check and correct if necessary. (CIPER 5)
- 6
- MESSAGE
Ldev #\ reports paper jam; please check and correct if necessary. (CIPER 6)
- 7
- MESSAGE
Ldev #\ reports platen open; please check and correct if necessary. (CIPER 7)
- 8
- MESSAGE
Ldev #\ reports ribbon error; please check and correct if necessary. (CIPER 8)
- 9
- MESSAGE
Ldev #\ experienced self-test failure. Failure code = !. (CIPER 9)
- 10
- MESSAGE
Ldev #\ reports protocol error: illegal header length received. (CIPER 10)
- 11
- MESSAGE
Ldev #\ reports protocol error: record sequence error in record received. (CIPER 11)
- 12
- MESSAGE
Ldev #\ reports protocol error: incorrect creator of record received. (CIPER 12)
- 13
- MESSAGE
Ldev #\ reports protocol error: undefined
command received. (CIPER 13)
- 14
- MESSAGE
Ldev #\ reports protocol error: undefined data type received. (CIPER 14)
- 15
- MESSAGE
Ldev #\ reports protocol error: illegal format number in environmental status block. (CIPER 15)
- 17
- MESSAGE
Ldev #\ reports protocol error: illegal block label length received. (CIPER 17)
- 18
- MESSAGE
Ldev #\ reports protocol error: transport service error. (CIPER 18)
- 19
- MESSAGE
Ldev #\ reports protocol error: data overrun from host. (CIPER 19)
- 20
- MESSAGE
Ldev #\ reports data loss. (CIPER 20)
- 30
- MESSAGE
CIPER ldev #\ is being shut down due to an internal data integrity error. Access to device will be denied until a WARMSTART is performed. (CIPER 30)
|
Break Handling (Subsystem 158) |
CIPER Device Manager |