RECALL/=RECALL

Parameters

None.

Operation Notes

A user, the system operator, a job or a program issues the RECALL command to determine if any pending resource requests are currently awaiting a response. Pending resource requests are responded to by using the REPLY command.

Use

This command may be issued from a session, job, program, or in BREAK. Pressing Break has no effect on this command. It may be issued only from the console.

Any user may execute the RECALL command. However, the CTRL A =RECALL command may only be executed at the physical console, and cannot be executed from a job or a program.

Examples

To display all pending system console messages, which require a response, enter:

   RECALL
  THE FOLLOWING REPLIES ARE PENDING:
  10:05/#J19/15/LDEV # FOR "L00576" ON TAPE1600 (NUM)?

If any replies are pending, the request(s) are displayed on the console as shown above. If no replies are pending, the following message appears on the console:

   RECALL
  NO REPLIES PENDING (CIWARN 3020)

Use the =RECALL command if the RECALL command is ineffective, or when a job or subsystem is being executed from the console.

   CTRL A
  =RECALL
  NO REQUESTS PENDING (SYS 15)