 |
» |
|
|
|
To rerun hpinstal and finish
applying the CSLT: Remount the CSLT
created by HPINSTAL. Reinvoke HPINSTAL
and resume
previous installation. If you are performing an Add-on or Update task,
go to Step 4. If you are performing a Modify Remote System task, go to Step
5.
Add-on Tasks, Update TasksResume previous installation. Type YES
at the prompt. If the CSLT was created on the system you are updating, the
system displays a message saying it located an old audit trail of
an incomplete installation (that is, HPINSTFL.INSTALL.SYS).
You must respond YES
and resume the installation to complete the task. Go to Step 5.
However, if you accidentally responded NO,
you can continue by performing the following: Exit hpinstal
by selecting Option 8. Reinvoke HPINSTAL
using the recovery
parameter: Go to Step 5.
If you are applying a CSLT to a Remote system, go
to Step 6. If you are performing an Add-on or Update task for the local
system only, go to Step 8.
Remote TasksDeny any
previous installation, if it exists. Type NO at the prompt. If you are modifying a remote system (the CSLT was created
on a local system) and the following message displays, it indicates
that HPINSTAL located an old audit
trail of an incomplete installation (that is, HPINSTFL.INSTALL.SYS).
You must respond NO
to properly complete your remote installation task. From the HPINSTAL
menu, select option 5, "Complete the update of this system
using a CSLT created on another system," to start the update
process on the remote system. 1 Update this system 2 Update this system and install patches from a PowerPatch tape 3 Create a CSLT for another system 4 Create a CSLT with PowerPatch patches for another system 5 Complete the update of this system using a CSLT created on another system 6 Add SUBSYS products to this system 7 Add SUBSYS products and install patches from a Powerpatch tape Enter your choice >>5
|
Go to Step 8. Restore the STORE
portion of the CSLT. Mount the CSLT tape and put the tape drive online. If using
DDS tape, remove the tape and reinsert
it now. Mount the CSLT and put the tape drive ONLINE. Skipping system files... The HP-supported software files will be restored.
|
The system then restores files, processes STORE
files, creates the accounting
structure, and processes
installation
files. FILES RESTORED. The SUBSYS tape has been successfully restored. Processing STORE Files . . . DONE DONE
|
The time it takes to restore the software files varies depending
on which specific subsystems you have on your system. Follow any additional instructions displayed on
the screen, such as mounting other tape volumes (if using half-inch
magnetic tapes). Reply to tape requests, if necessary. When HPINSTAL
finishes the task, you will see the following message: The installation is now complete.
|
Install products that cannot be installed automatically. Refer to the list of products in Appendix A “Manually Installed Products” and follow the directions on installing
these products. Rerunning HPINSTAL completed.
Go to the next section on your checklist.
|