 |
» |
|
|
|
To rerun AUTOINST
and finish applying the CSLT: Remount the combined
CSLT/store tape created during
the first run of AUTOINST. If the CSLT is two reels, begin by loading the second reel
because the STORE files are appended to the CSLT. The program will
prompt you if the first reel is also required. Reset the outfence. Run AUTOINST to
resume previous installation. :RUN AUTOINST.INSTALL.SYS
|
Respond YES to
resume
installation. If the system displays a message saying that is located an
old audit trail of an incomplete installation (that is, HPINSTFL.INSTALL.SYS).
You must respond Y
and resume the installation to complete the task. MPE/iX AUTOINST D.10.11 (C) HEWLETT-PACKARD CO. An old audit trail of an incomplete installation has been found. If you would like to RESUME with that installation, respond `YES' to the following prompt. If you would like to RESTART from the beginning, respond `NO'. Should the installer resume with the previous installation? Y
|
If you accidentally respond NO,
you can continue by performing the following: Exit AUTOINST
by selecting Option 6. Reinvoke AUTOINST
using the recovery
parameter:
AUTOINST begins to modify
the system and displays progress messages. Mount the CSLT/STORE tape and put the tape drive online. ***** Please stand by ***** The patched STORE files from the CSLT/STORE tape are being restored. . . . The STORE files from the CSLT/STORE tape were successfully restored.
|
Reply to the tape request. The time required to restore the STORE
files depends on the number of files to restore, and may take up
to 10 minutes (per 2400-foot reel). AUTOINST
automatically streams the installation jobs that complete
the installation of most products. The following progress messages are displayed: Begin processing installation files. Processing n installation files. . . . * the number of dots equals n *
|
The message may indicate zero installation
files. This only means that the products you are installing do not
require an installation file. AUTOINST
continues with the product installation. When all installation
jobs are complete, the following message displays: All product installation jobs have been streamed successfully.
|
When AUTOINST successfully
completes its processing, an END OF PROGRAM
message displays. In addition to streaming installation jobs, AUTOINST
removes temporary files that were used during earlier phases of
the process.
Dismount the CSLT. Rerunning AUTOINST completed.
Go to the next section on your checklist.
|