 |
» |
|
|
|
To shut down the remote system: Log onto the
remote system console. :HELLO MANAGER.SYS,INSTALL;HIPRI :SPOOLER LP;START :STREAMs streams_device
|
A common streams_device
value is 10. An LP device must be configured
in SYSGEN. Already spooled and
streamed messages might display. Shutdown
the system. Reset the system
after
the last shutdown message (SHUT6). If you have
an HP 3000 Series 99x, connect to the service processor before you
can restart the system. Type the following: Enter Y to HARD BOOT
the computer system. Do not respond to the question: Press any key within 10 seconds to cancel boot with this configuration.
|
There are 5 to 10 minutes of system activity, then the Processor
Dependent Code (PDC) screen displays. For all other systems, enter the following commands
to reset the system: If the system does not respond to the CTRL-B
entry within ten seconds, press the reset button, key switch, or
on/off switch as appropriate for your system. The system will halt,
and then restart automatically. Enter Y to confirm restarting
the system.
Shutting Down the Remote
System completed. Go to the next section on your checklist.
|