 |
» |
|
|
|
A staging area requires a minimum amount of non-contiguous
disk space sectors. Ensure that you have enough non-contiguous disk
space on LDEV 1 to complete your task. To verify the remote system has enough disk space: Log
onto the console on the remote system with the following
conditions: :HELLO MANAGER.SYS,INSTALL;HIPRI
:SPOOLER LP;START
:STREAMS streams_device |
An LP device must be configured in SYSGEN.
A common streams_device
value is 10. Already spooled and streamed messages might display. Verify disk space availability on your remote system.
Log onto
the remote system. Check for available disk space on LDEV1 using DISCFREE. :RUN DISCFREE.PUB.SYS;INFO= "C,1,mpexl_system_volume_set" |
where mpexl_system_volume_set is
the name assigned to the system volume set.
If the AVAIL TO PERM SPACE
on LDEV 1 is greater than the staging area disk space calculated
in "Estimating Disk Space," proceed with your
task. If the AVAIL TO PERM SPACE
is not greater than the staging area disk space calculated in "Estimating
Disk Space," you need to make more space available on your
system before you continue with your task. Refer to Appendix C “Managing Disk Space” for information
on finding additional disk space. Reserving Disk Space for
Distributing Areas completed. Go to the next section on your checklist.
|
