Use this task checklist if your source material is on CD-ROM
and you are using a CSLT tape to:
Update your
system software version level
 |
 |  |
 |
 | NOTE: You cannot apply Reactive patches at the same time you
are updating the system. You must apply Reactive patches after you
update the system. To apply Reactive patches (after you update the
system) refer to the Checklist A, "Manage Patches,"
or Checklist B, "Manage Patches by Staging Area." |
 |
 |  |
 |
Print a copy of this checklist for each system that you are
updating. Read and perform the steps only in the following sections:
Begin Preparation Tasks. Does not require exclusive access to the system.
Chapter 3 “Planning for Your Task”
3.1 Verifying Required Materials
3.2 General Planning Tasks
3.3 CD-ROM Planning Tasks
3.6 Estimating Disk Space
Record contiguous disk space:
Record non-contiguous disk space:
Chapter 4 “Preparing Your System”
4.3 Preparing to Run HPINSTAL
Record CD v.uu.ff version level:
4.6 Creating the CSLT using HPINSTAL
Record manually installed products:
4.12 Reserving Disk Space for CD-ROM Tasks
Record contiguous disk space:
Record non-contiguous disk space:
Preparation Tasks completed. Schedule downtime for exclusive access.
If you are not applying this update to a master system, and
instead are only creating a CSLT on a master system to apply to
a remote system, you can now proceed to the Checklist I, "Modify
Remote System."
Begin Exclusive Access Tasks.
Chapter 5 “Modifying Your System”
5.11 Securing the System
Record terminated logging processes:
Record temporary filename for the COMMAND.PUB.SYS
file:
5.13 Applying the CSLT Modification
5.14 Restarting the System
Chapter 6 “Finishing the Process”
6.1 Configuring Datacomm and UPS
6.4 Setting Passwords, Lockwords, and UDCs
6.5 Configuring Manually Installed Products
6.6 Setting Up the TAR Utility
6.7 Performing the Final Reboot
6.8 Restarting Selected System Functions
6.9 Backing Up Your System
Checklist H tasks completed.
If you are also applying the CSLT onto a remote system, perform
the steps on the following checklist:
Checklist I, "Modify Remote
System"
If you have Reactive patches to apply, proceed to one of these
checklists:
Checklist A, "Manage Patches"
Checklist B, "Manage Patches by Staging
Area"
Record system change: