HP 3000 Manuals HP 3000 Manuals
Are You Ready?
Every HP 3000 Series 9X8LX arrives with HP Easytime/iX preinstalled. If
you did not receive HP Easytime/iX installed as part of your system, you
need to install the software before you can use the program. You receive
the program on either a 1/2-inch magnetic tape or on a digital data
storage (DDS) cassette.
To install HP Easytime/iX
MPE/iX system manager or operator capabilities are required to install HP
Easytime/iX. Follow the installation instructions that you received with
your tape.
To customize HP Easytime/iX
If you are the system manager, you can use the setup program to customize
the HP Easytime/iX program. See "Customizing HP Easytime/iX" in chapter
3 of this manual. This program is optional. HP Easytime/iX arrives set
up for you. You can use it as is, or customize it to meet your
particular needs.
To enable HP Easytime/iX
Before you can use HP Easytime/iX, the program must be enabled. This is
a system administrator responsibility. If you are not the system
administrator, ask the system administrator to do this for you.
1. Log on to the system as MANAGER.SYS.
2. From the system prompt, type:
:RUN EASYTIME.PUB.SYS Return
3. Press F5 OK to enable HP Easytime/iX.
You can now start HP Easytime/iX and begin performing tasks. If,
at some later time, you need to disable HP Easytime/iX again, see
the following procedure.
To disable HP Easytime/iX
Disabling HP Easytime/iX is a system administrator responsibility. You
may want to do this, for example, before a system shutdown.
1. Log on to the system as MANAGER.SYS.
2. Start HP Easytime/iX.
3. Switch to system administrator mode.
4. From the Main menu, press D for Disable HP Easytime/iX.
A dialog box prompts you for confirmation.
5. Press F5 OK to confirm disabling HP Easytime/iX.
6. Press F5 Yes to confirm again.