HP 3000 Manuals HP 3000 Manuals
SECURE
This command reinstates all file security provisions that you previously
suspended with the RELEASE command.
Syntax
SECURE filereference
Parameters
filereference Specifies the actual file designator for which you
want to reinstate file access control. The
filereference can be either in MPE or HFS syntax.
MPE Syntax
If the filereference does not begin with a dot or a
slash, it is parsed according to the MPE syntax and
has the form:
filename[/lockword][.groupname[.acctname]]
If the file has a lockword, you must specify it;
otherwise, the system prompts you for it. If you
do not specify groupname.acctname, the system
assumes the logon group and account.
HFS Syntax
If the filename begins with a dot (.) or a slash
(/), it is parsed according to HFS syntax.
Operation Notes
* Usage
You can enter this command from a session, a job, a program, or in
break mode. Pressing Break does not affect this command.
You can use this command only for permanent disk files you
created. Under default system security provisions, the file must
be in your logon account and must belong to your logon or home
group.
* Checking the file status
You can enter the LISTFILE command to determine if a file is
currently released or secured. Refer to the LISTFILE command in
this book for more information.
* Access control definition
An access control definition (ACD) overrides file access controls
whether or not you have released or secured the file.
Example
* To reinstate file access control previously in effect for the file
named FILE1, enter:
:SECURE FILE1
Related Commands
ALTSEC
LISTF
LISTFILE
RELEASE