HP 3000 Manuals

HP 3000 Series 9X8LX Computer Systems Commands Reference

RESUME 

The RESUME command resumes execution of a program or subsystem command
that was suspended after you pressed the Break key.  The program resumes
at the point where execution was suspended.

Syntax 

RESUME

Parameters 

None.

Operation Notes 

   *   Usage 

       You can only enter this command in break mode.  You cannot enter
       this command from a job, a program, or a session (unless in break
       mode).  Pressing Break does not affect this command.

   *   Entering commands other than RESUME 

       If you enter a program or subsystem command after pressing Break,
       the command interpreter prints the following message on your
       terminal:  ABORT? (YES/NO). If you respond YES to the message, the
       command interpreter aborts the currently suspended program.  If
       you respond NO to the message, the command interpreter prints the
       message COMMAND NOT ALLOWED IN BREAK and prompts you for another
       command.  If you now enter RESUME, the suspended program resumes
       at the point where it was interrupted.

       You can enter most commands after pressing Break.  Only the
       commands that create processes require you to resume or abort the
       interrupted program.

Example 

   *   To continue a suspended program at the point of interruption, do
       the following:

          1.  Enter the following command:

                   :RESUME 

              The system responds by displaying the following message:

                   READ PENDING

          2.  Press Return to resume the program.

Related Commands 

     ABORT

MPE/iX 5.0 Documentation