HP 3000 Manuals

HP 3000 Series 9X8LX Computer Systems Commands Reference

BREAKJOB 

The BREAKJOB command suspends any executing job, including spooled and
streamed jobs.  A job using a critical system resource does not suspend
until it releases the resource. 

Syntax 

BREAKJOB #Jnnn 

Parameters 

#Jnnn                 Specifies a job number.

Operation Notes 

   *   Usage 

       You can enter this command from a session, a job, a program, or in
       break mode.  Pressing Break does not affect this command.

       You must enter this command from the console.  You can enter this
       command from a terminal other than the console under one of the
       following conditions:

          *   The JOBSECURITY command is set to LOW and the job is logged
              on to your user account.  (AM users only need to match the
              job's account name.)

          *   Your system administrator has used the ALLOW command, which
              permits you to enter this command.

   *   Nonshareable devices 

       When you enter this command for a job that controls a nonshareable
       device, a console message appears that lists the device(s) that
       the job controls.  As many as ten devices may be listed.  You can
       then decide whether to allow the job to continue running until it
       releases the device(s), or whether you should abort the job.

Examples 

   *   To suspend the processing of job number 68, enter:

            :BREAKJOB #J68 

   *   To display suspended jobs, enter:

            :SHOWJOB SUSP 
            JOBNUM  STATE  INPRI  JIN  JLIST  INTRODUCED   JOB NAME
            #68     SUSP          105    LP   WED. 7:56AM  TEST,USER.ACCT

Related Commands 

     ALTJOB
     ABORTJOB
     CONSOLE
     JOBSECURITY
     RESUMEJOB
     SHOWJOB
     STREAM

MPE/iX 5.0 Documentation