HP 3000 Manuals HP 3000 Manuals
Appendix A Troubleshooting
If you have problems in getting the correct results from the
demonstration programs, here are some suggestions.
The pi Program When you are running pi, if anything other than the
illustrated result appears on your screen, the most
likely cause is that your environment has not been
correctly configured. Check that the operating
system terminfo entry for your terminal type is
correct and that the TERM environment variable is set
correctly.
The stock1 Program When you are running stock1, typical problems that
you could have are:
* The cursor fails to move, or moves incorrectly, with one or more
of the cursor movement keys. If you are using the keys correctly,
the operating system terminfo entry for your terminal type may be
incorrect.
* A run-time error message may occur if the files STOCK.IT and
STOCK.IT.idx,generated and referenced by stock1, have been
corrupted; for example, by a previous run of stock1 that was
incorrectly terminated. To recover, delete these two files and
start again with the stock1 program.
If you still have problems, see the section Contacting Micro Focus in the
chapter Welcome! for how to obtain technical support.