HP 3000 Manuals HP 3000 Manuals
Additional Parameters
The EXPERT USERS parameter can control which users are allowed
to use the Expert facility (who can execute X commands or
utilize continuous mode).
DEFAULT: ANY (Any user may use the Expert facility.)
GLANCNFG: XPERT SM, OP, AM, ANY (or any combination to
allow users with SM, OP, AM capabilities or ANY
user to use the Expert facility.)
XPERT NONE (Prevents all users from accessing
the Expert facility.)
JCW: (This capability is not accessible through Job
Control Words.)
VALUES: (This capability is not accessible through any
GlancePlus commands.)
The QZAP parameter is only allowed in the GLANCNFG file. It
can control which users are allowed to execute the QZAP command
to change the priority of a process, job, or session.
DEFAULT: SM (Only system managers may execute the QZAP
command.)
GLANCNFG: QZAP SM (Only system managers may execute the
QZAP command.)
QZAP OP (System operators--or users with OP
capability--may execute the QZAP command but not
into or out of the B or linear queues.)
QZAP NONE (No user may execute the QZAP
command.)
The QZAPSYS parameter is only allowed in the GLANCNFG file. It
controls which users are allowed to execute the QZAP command
against system processes. Combinations of OP and SM are
allowed in this parameter. Care must be taken when adjusting
system process priorities since this might degrade performance,
cause errors, or even hang or crash the system.
DEFAULT: NONE (No user may QZAP a system process.)
GLANCNFG: QZAPSYS SM and/or OP (To allow users with SM
and/or OP caps.)
The REFRESH TIME parameter determines how many seconds between
automatic updates of the GlancePlus display.
DEFAULT: 30 seconds
GLANCNFG: REFRESH seconds
JCW: SETJCW GLANCETIME=seconds
VALUES: Not used. Use the I (Interval) or T (Time)
command, or press f5.