Ch 11. Regulatory Notices [ Setting Up and Maintaining Your System The Installation Guide ] MPE/iX 5.0 Documentation
Setting Up and Maintaining Your System The Installation Guide
Chapter 11 Regulatory Notices
Safety and Regulatory Information
Figure 11-1. Declaration of Conformity
For your protection, this product has been tested for conformance to
various national and international regulations and standards. The scope
of this regulatory testing includes electrical and mechanical safety,
electromagnetic emissions, immunity, acoustics and hazardous materials.
When required, approvals are obtained from third party test agencies.
Approval marks appear on the product label. In addition, various
regulatory bodies require some information under the headings noted
below.
FCC STATEMENT (USA Only)
The United States Federal Communications Commission (in 47 CFR 15.838)
has specified that the following notice be brought to the attention of
users of this product.
WARNING: This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with the instructions
manual, may cause interference to radio communications. It has been
tested for compliance with the limits of Class A computing devices
pursuant to Subpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference.
Operation of this equipment in a residential area is likely to cause
interference in which case the user at his own expense will be required
to take whatever measures may be required to correct the interference.
DOC STATEMENT (Canada Only)
This equipment does not exceed the Class A limits for radio noise
emissions as set out in the Radio Interference Regulations of the
Canadian Department of Communications.
Germany EMI (Germany Only)
This is to certify that this product meets the Radio Frequency
Interference Requirements of Directive 1046/84. The German Bundespost
has been notified that this equipment has been put into circulation and
has been granted the right to check the product type for compliance with
these requirements.
FUNKENTSTORUNG DEUTSCHLAND (German EMI Compliance)
HERSTELLERBESCHEINIGUNG
Hiermit wird bescheinigt, das dieses gerat in Ubereinstimmung mit den
Bestimmungen von Postverfugung 1046/84 funkentstort ist.
Der Deutschen Bundespost wurde das Inverkehrbringen dieses gerat
angezeigt und die Berechtigung zur Uberpruefung de Serie auf Einhaltung
des Bestimmungen eingeraumt.
JAPAN VCCI (Japan Only)
ACOUSTICS (Germany)
Laermangabe (Schalldruckpegel LpA) gemessen an Arbitsplatz bei normalem
Betrieb nach DIN 45635, Teil 19:
Acoustic Noise (A-weighted Sound Pressure Level LpA) measured at
operator's position, normal operation, to ISO7779:
HP 3000 917LX, 927LX, 937LX, 947LX, 957LX and 967LX:
47dB bis (up to) 30 to 37 degrees C, 50dB ueber (above) 30 to 37 degrees
C
UNITED KINGDOM (Only)
Pursuant to Section 22 of Telecommunications Act of 1984, this product is
approved for indirect connection to Public Telecommunications
systems within the United Kingdom under the General Approval number
NS/G/1234/J/100003.
WARNING: UK Only!
The following notice is required by the British Approvals Board for
Telecoms (BABT). Please contact your HP Sales Office if there are any
questions.
"Interconnection directly, or by way of other apparatus, of ports marked
with `United Kingdom Safety Warning: Refer to users instructions' with
ports marked or not so marked may produce hazardous conditions on the
telecom network. Advice should be obtained from a competent engineer
before such a connection is made."
To prevent an electric shock to the operator, disconnect this product
from the BT network before the mains plug is removed. Do not hard-wire
the BT network connection.
Connect only products complying with BS6301 or EN41003 to the IO ports on
this product.
The United Kingdom Safety Warning applies to all ports.
BATTERY NOTICES
This product may contain a sealed Lead Acid and a Lithium battery.
Replace only with the same type and part number! Recycle used battery or
send to the following address for proper disposal:
Hewlett Packard Co.
Environmental Health and Safety Department
8000 Foothills Boulevard
Roseville, CA 95678
Attn: Battery Disposal Coordinator
WARNING: Fire, explosion and severe burn hazard! Do not crush,
disassemble, heat, incinerate or expose the battery to water.
SAFETY WARNINGS
This product has not been evaluated for connection to an "IT" power
system (ac distribution system having no direct connection to earth
according to IEC 950).
Locate the ac outlet near the computer! The ac power cordset is this
product's main ac disconnect device and must be easily accessible at all
times.
To reduce the possibility of an electric shock from the telephone
network, plug the computer into the ac outlet prior to connecting to the
network. Also, disconnect the network before unplugging the computer
from the ac power outlet.
To reduce the risk of electric shock, ensure the front and rear bezels
are installed at all times!
This product is designed to operate at the ac line voltages of 100, 120,
220, or 240 V +/- 10%. Contact your HP Sales Office if your line voltage
is outside this range.
DECLARATION OF CONFORMITY
according to ISO/IEC Guide 22 & EN 45014
MANUFACTURER'S NAME: Hewlett-Packard
MANUFACTURER'S ADDRESS:
Herrengerger Strasse 130, 7030 Boeblingen, Germany
8000 Foothills Blvd., Roseville, CA 95679, U.S.A.
DECLARES, THAT THE PRODUCT
PRODUCT NAME: Computer System
MODEL NUMBER: HP 3000 Series 9X7LX
CONFORM TO THE FOLLOWING PRODUCT SPECIFICATION:
Safety: EN 60950 (IEC 950)
EMC: EN 55022 class A
MPE/iX 5.0 Documentation