HP 3000 Manuals HP 3000 Manuals
HP 50759B Modem Configuration
The summary "cells" that would appear in tables 3-3 and 3-4 are as
follows:
Table C-1. Settings for Supported Modems Connected to a DTC
-------------------------------------------------------------------------------------------
| | | | |
| Modem | Configuration | Configuration | Configuration |
| | Type 1 | Type 2 | Type 3 |
| | | | |
-------------------------------------------------------------------------------------------
| | | | |
| HP 50759B | S2, S3, S4, S7, | S2, S3, S4, S7, S8, S9, | Do not use in this |
| | S9, S12, S16: | S12: DOWN All others: | configuration |
| | DOWN All others: | UP | |
| | UP | | |
| | | | |
-------------------------------------------------------------------------------------------
Table C-2. Settings for LAN/Console Card
-------------------------------------------------------------------------------
| | |
| Modem | Configuration Using the LAN Console Card |
| | |
-------------------------------------------------------------------------------
| | |
| HP 50759B | S2, S3 S4, S7, S8, S9, S12, S16: DOWN All |
| | others Up |
| | |
-------------------------------------------------------------------------------
The detailed table that would appear in Appendix C, if the HP 50759B were
covered there, appears below. The switches on the HP 50759B can be set
to either of two positions: UP or DOWN (depressed).
Table C-3. Switch Settings for the HP 50759B
----------------------------------------------------------------------------------
| | | |
| For This | Set the Switch | Special Comments |
| Configuration Type | Keys | |
| | As Follows | |
| | | |
----------------------------------------------------------------------------------
| | | |
| 1 | S2, S3, S4, S7 S9, | PSCONFIG Values: |
| | S12, S16: DOWN | |
| | All other | * Dial out = Manual |
| | switches: UP | * Baud = 1200 or 2400 |
| | | |
----------------------------------------------------------------------------------
| | | |
| 2 | S2, S3, S4, S7 S8, | PSCONFIG Values: |
| | S9, S12: DOWN All | |
| | other switches: | * Dial out = Autodial |
| | UP | * Baud = 1200, 2400 or |
| | | AUTOSELECT |
| | | * RC phone number |
| | | |
| | | The Response Center Phone Number in |
| | | psconfig must be preceded by the |
| | | following special characters in the |
| | | order presented. Configure the |
| | | Response Center phone number through |
| | | the Configure Transfer Information |
| | | menu of psconfig: |
| | | |
| | | |
| | | 1. T (for tone) or P (for pulse) |
| | | to match the characteristics |
| | | of the phone line |
| | | |
| | | 2. B (for blind dialing), if |
| | | applicable, for dialing |
| | | without requiring a dial tone |
| | | |
| | | |
| | | 3. If the modem must dial |
| | | through a PBX (Private Branch |
| | | Exchange): |
| | | |
| | | |
| | | a. 9 (or equivalent to |
| | | reach an outside line) |
| | | |
| | | |
| | | b. , (a comma, the delay |
| | | character that ensures |
| | | a dial tone is reached |
| | | before other numbers |
| | | are dialed) |
| | | |
| | | 4. 1 (or equivalent), if |
| | | required, for long distance |
| | | dialing |
| | | |
| | | 5. The Response Center phone |
| | | number follows the delay |
| | | character, or the long |
| | | distance access code, as |
| | | appropriate. Do not use |
| | | spaces, dashes, or |
| | | parentheses when entering the |
| | | Response Center phone number. |
| | | For example: |
| | | |
| | | T9,18002588884 |
| | | |
----------------------------------------------------------------------------------
| | | |
| 3 | Do not use in this | None. |
| | configuration. | |
| | | |
----------------------------------------------------------------------------------
| | | |
| LAN/Console card | S2, S3, S4, S7, | Same as Type 1 or 2 above |
| | S8, S9, S12, S16: | |
| | DOWN All other | |
| | switches: UP | |
| | | |
----------------------------------------------------------------------------------