HP 3000 Manuals HP 3000 Manuals
HP 37212A The options on this modem are controlled by switches inside the modem. This requires you to remove the modem cover (see instructions below).
NOTE There may be several jacks on the back panel of the modem. Make sure the telephone line is entered into the "TELCO" jack when connecting the modem to the system.
Prepare the Modem 1. Disconnect the AC power cord from the modem. 2. Remove the plastic trim on the front and rear of the modem, as follows: a. Place your thumbs on the sides of the plastic trim. b. Push outward with your thumbs and move the trim forward. 3. Unscrew all screws holding the top cover; remove it. The configuration switches are located near the front panel and are numbered S9 through S16 on the PC board. Set the Options Set the options to either the CLOSED position or the OPEN position. Move the switches as follows: * To the Left, to set the switch in the OPEN position. * To the Right, so set the switch in the CLOSED position. Table C-1 lists the HP 37212A switch settings for each configuration type and the LAN console card. Table C-1. Switch Settings for the HP 37212A --------------------------------------------------------------------------------- | | | | | For This | Set the Switch Keys | Special Comments | | Configuration | As Follows | | | Type | | | | | | | --------------------------------------------------------------------------------- | | | | | 1 | All switches: OPEN | None. | | | | | --------------------------------------------------------------------------------- | | | | | 2 | S10: CLOSED | Special Characters For HP Response | | | All other switches: OPENnter Phone Number in psconfig: | | | | | | | | The following special characters, in | | | | the order presented, must precede | | | | the HP Response Center phone number | | | | configured through Configure | | | | Transfer Information Menu: | | | | | | | | | | | | 1. T (for tone) or P (for pulse) | | | | to match the characteristics | | | | of the phone line. | | | | | | | | 2. If the modem must dial | | | | through a PBX (Private Branch | | | | Exchange): | | | | | | | | | | | | a. 9 (or equivalent to | | | | reach an outside | | | | line-must assume the | | | | second position) | | | | | | | | b. % (delay character to | | | | ensure that a dial | | | | tone is reached-must | | | | assume the third | | | | position)) | | | | | | | | 3. 1 (or equivalent), if | | | | required for long distance | | | | dialing (must follow any PBX | | | | characters). | | | | | | | | The HP Response Center phone number | | | | follows the delay character or long | | | | distance access code, as | | | | appropriate. Do not use spaces, | | | | dashes, or parentheses when entering | | | | the HP Response Center phone number. | | | | For example: | | | | | | | | T9%18002588884 | | | | | --------------------------------------------------------------------------------- | | | | | 3 | S9: CLOSED | See the comment above on special | | | All other switches: OPENaracters. | | | | | --------------------------------------------------------------------------------- | | | | | LAN console | All switches: OPEN | | | card | | | | | | | ---------------------------------------------------------------------------------