HP 3000 Manuals HP 3000 Manuals
Cannot Connect to the Remote Host
* Did you enter the correct ARPA domain name, IP address, or NS node
name? See your network administrator.
* Check with your network administrator to find out the following:
* Does the remote host system support TELNET?
* Is the network link active on the remote host system?
* If an NS node name was used, make sure it is correctly
entered in the network directory. If an ARPA domain name
was used, make sure the name has been configured in the two
required ASCII files. If not, use the IP address.
* Use the PING test of NETTOOL to verify the remote system is
responding on the network.
NETTOOL is documented in the NS 3000/iX Operations and
Maintenance Reference Manual (36922-90035).