HP 3000 Manuals HP 3000 Manuals
Chapter 7 Managing Networks with DTCCNTRL
This chapter describes the syntax of the DTCCNTRL command and how it is
used. DTCCNTRL is a command file that is used to start, stop, and obtain
status about host-based X.25 system-to-system and PAD connections;
dynamically implement changes that were made to the DTS subsystem in
NMMGR; shutdown and restart the DTS subsystem; automatically add a new
DTC. Additional information on dynamic configuration, automatic
configuration, and DTS shutdown and restart is contained in the
Configuring Systems for Terminals, Printers, and Other Serial Devices
manual. The capabilities required to use DTCCNTRL depends on the
operation selected. System Manager (SM) is required to shutdown and
restart the DTS subsystem. Network Manager (NM) or System Manager (SM)
is required to perform dynamic or automatic configuration. System
Operator (OP), Network Administrator (NA) or Network Manager (NM) is
required to obtain dynamic configuration or X.25 card status or start and
stop X.25 and PAD services.
This chapter includes the following:
* A description of the syntax and parameters of the DTCCNTRL
command.
* An overview of the Dynamic Configuration capability of the
DTCCNTRL command.
* An overview of the Automatic Configuration capability of the
DTCCNTRL command.
* An overview of the DTS shutdown and restart capability of the
DTCCNTRL command.
* A discussion of the start, stop, and X.25 status capability of the
DTCCNTRL command.