HP 3000 Manuals HP 3000 Manuals
Appendix A LINKCONTROL Command This appendix defines the fields output by the LINKCONTROL STATUS command and its associated parameters. The LINKCONTROL STATUS command enables you to obtain link configuration and statistical data which you can use for monitoring and debugging the link. This command has several parameters, each of which provides different configuration or statistical data. The parameters described in this appendix are as follows: * LINKSTATE. * CONFIGURATION. * STATISTICS. * ALL. * RESET. The STATUS=DIAGSTAT command returns information intended for HP diagnostic use. Its output is not explained in this manual. After issuing this command you should send the output to your HP representative. The LINKCONTROL command displays specific information relating to the type of link that is monitored. The LINKCONTROL command can be used to obtain information about the following types of NS3000/iX links: * NS3000/iX LAP-B links. * NS3000/iX IEEE 802.3/Ethernet (LAN) links. * NS3000/iX Token Ring links. * NS3000/iX Fiber Distributed Data Interface (FDDI) links. The LINKCONTROL command does not work on an X.25 link because the card is located in the DTC. For equivalent functionality, use the OpenView DTC manager.