HP 3000 Manuals HP 3000 Manuals
Using The Path Name
The path name is used to go directly to a given screen. A path name may
include one or more of the following variables:
* NIname is the name of the network interface you want to modify.
* linkname is the name of the link you want to modify.
* gatewayn is the name of the gateway you want to modify.
* mapentry is the name of the entry you want to modify in the router
mapping table.
* fsetname is the name of the X.25 facility set you want to modify.
The path name is specified with each screen in this manual. To use a
path name to go directly to a screen, type the path name preceded by an
"@" in the command window and press the [Enter] key. For example, to go
directly to the screen that contains the parameters for the X.25 facility
set called "MySet" for the NI called "MyX25NI", you would type the
following:
@NETXPORT.NI.MyX25NI.PROTOCOL.X25.FACSET.MySet