HP 3000 Manuals

NS3000/iX NMMGR Screens Reference Manual

Protocol Configuration  

The Protocol Configuration screen (#113) in figure 6-4 is displayed when
you press the [Go To PROTOCOL] function key at the Point-to-Point Network
Interface Config screen (figure 6-3).  It is also displayed when you type
the path name:

@NETXPORT.NI.NIname.PROTOCOL

in the Command window of any screen and press the [Enter] key, where
NIname is a configured point-to-point (router) NI name.


          Figure 6-4.  Protocol Configuration 

For a point-to-point NI, you must configure the IP protocol.  The Dial
protocol must be configured if you have switched lines. 

Choose the protocol to configure and press the corresponding function
key.

MPE/iX 5.0 Documentation