HP 3000 Manuals

ALLBASE/Turbo CONNECT Administrator's Guide

About the Tasks 

 *  Each task is divided into three parts:

    Getting Ready       describes preparatory steps and gives information
                        you need to know before performing the task.

    Performing the      describes how to perform the task.
    Task 

    Task Reference      lists information useful when performing the task
                        and provides cross-references to related tasks.

 *  To perform most tasks you must be attached to the DBEnvironment.
    Here are some general guidelines:

     *  To issue the SET commands, you must be the creator or supply the
        maintenance word of the TurboIMAGE/XL database or DBEnvironment
        named in the command.

     *  For most other commands you must be a DBA of the DBEnvironment.
        For commands involving database security, you must be the DBC.
        The maintenance word is not sufficient.

 *  Figure 2-1 shows the prerequisites needed to issue all ATCUtil
    commands.  For complete ATCUtil command syntax, refer to chapter 4,
    "ATCUtil Command Syntax."


          Figure 2-1.  ATCUtil command prerequisites  

MPE/iX 5.0 Documentation