HP 3000 Manuals HP 3000 Manuals
Installing HP ALLBASE/4GL
To complete the installation of HP ALLBASE/4GL some additional steps must
be performed.
These installation procedures must be completed on a terminal other than
the system console. HP ALLBASE/4GL cannot be run on the system console.
To install new HP ALLBASE/4GL systems
To complete the installation of the HP ALLBASE/4GL Developer system or
the HP ALLBASE/4GL Run-Time Environment, perform the following steps
after the AUTOINST has run.
1. Create the account in which you want to use HP ALLBASE/4GL. You
can select any name for the account, but we suggest that you use
the name HP4GL for the HP ALLBASE/4GL Developer System, and HP4GLR
for the HP ALLBASE/4GL Run-Time Environment.
Developer
:HELLO MANAGER.SYS
:NEWACCT HP4GL,MGR;PASS=password;CAP=AM,AL,GL,ND,SF,BA,IA,PH
or
Run-Time
:HELLO MANAGER.SYS
:NEWACCT HP4GLR,MGR;PASS=password;CAP=AM,AL,GL,ND,SF,BA,IA,PH
2. Log on to the new account and execute the following command file:
Developer
:HELLO MGR.HP4GL
:HP4BLD.HP4GL.SYS
or
Run-Time
:HELLO MGR.HP4GLR
:HP4BLDR.HP4GLR.SYS
HP4BLD (or HP4BLDR) will create several groups within the account.
After the groups are created, the utility copies several files
from the SYS account into the newly created groups.
To install the HP ALLBASE/4GL environment
The default HP ALLBASE/4GL installation assumes that the MPE/iX system is
configured to support the American version as well as the "native
computer" language.
To run HP ALLBASE/4GL on a terminal that supports the line-drawing
character set, set the MPE/iX variable HP4TERM as follows:
:SETVAR HP4TERM "HPL"
Refer to the HP ALLBASE/4GL Developer Administration Manual (30601-64001)
or the HP ALLBASE/4GL Run-Time Administration Manual (30602-64001) for
further information on setting up the HP ALLBASE/4GL environment.
HP ALLBASE/4GL is now ready to be run.